Aem Infinity Supported Applications - Universal V8 Eng Bedienungsanleitung PDF herunterladen (Seite 11)

Universal 8

MSD Distributor + ATI AEM 24 Tooth + Honeywell High Output VR

Sensor

1. Modify and install mechanical advance distributor. (See Modifying Mechanical Advance Distributor, in

this document.)

2. Install ATI AEM Infinity crank trigger. (Note that an adjustable sensor mount is not provided with the

ATI crank trigger.) Position the crank sensor to be near the middle of its adjustment range while being

in between crank teeth with the engine at TDC. Set sensor output to .011”.

3. Wiring – note that the Infinity ECU can only accept falling edge VR/mag wave forms. If in doubt, verify

sensor signal with an oscilloscope.

Crank Sensor – Honeywell High Output VR

Sensor

Cam Sensor – Modified MSD Distributor

Wire

Desc

Connect To

Wire

Desc

Connect To

White

Crank signal +

C1-45 Crk Pos Sens VR+

Black/Purple

Cam signal +

C1-48 Cam Pos Sens 1 VR+

Black

Crank signal -

C1-46 Crk Pos Sens VR-

Black/Orange

Cam signal -

C1-47 Cam Pos Sens 1 VR-

Note: Use shielded twisted pair wiring w/drain

to ground.

Note: Use shielded twisted pair wiring w/drain to ground.

4. Load ATI 24 + Honeywell HO VR base session and review Setup Wizard. (See Setup Wizard, in this

document.)

5. Sync ignition timing. (See Syncing Ignition Timing, in this document.)

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 45 46

Keine Kommentare

Aem Infinity Supported Applications - Universal V8 Eng Bedienungsanleitung Seite 11