Aem Infinity Supported Applications - Universal V8 Eng Bedienungsanleitung PDF herunterladen (Seite 9)

Universal 8

MSD Distributor + MSD 4 Magnet Crank Trigger Kit

1. Modify and install mechanical advance distributor. (See Modifying Mechanical Advance Distributor, in

this document.)

2. Install MSD crank trigger kit. Orientate crank trigger wheel such that the arrow on the face of the

trigger wheel is between the 10 o’clock and 11 o’clock position with the engine at TDC. Position the

crank sensor such that it’s approximately in the middle of the adjustment range. Set sensor air gap to

.060”.

3. Wiring – note that sensor wiring may be different from what MSD instructions indicate. The Infinity

ECU can only accept falling edge VR/mag wave forms. If in doubt, verify sensor signal with an

oscilloscope.

Crank Sensor – MSD Non-Magnetic VR Sensor

Cam Sensor – Modified MSD Distributor

Wire

Desc

Connect To

Wire

Desc

Connect To

Green

Crank signal +

C1-45 Crk Pos Sens VR+

Black/

Purple

Cam signal +

C1-48 Cam Pos Sens 1 VR+

Purple

Crank signal -

C1-46 Crk Pos Sens VR-

Black/

Orange

Cam signal -

C1-47 Cam Pos Sens 1 VR-

Note: Use shielded twisted pair wiring w/drain to

ground.

Note: Use shielded twisted pair wiring w/drain to

ground.

4. Load MSD Crank Trigger base session and review Setup Wizard. (See Setup Wizard, in this

document.)

5. Sync ignition timing. (See Syncing Ignition Timing, in this document.)

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 45 46

Keine Kommentare

Aem Infinity Supported Applications - Universal V8 Eng Bedienungsanleitung Seite 9